Hello,
I want to model a double rink on esyview2.
the overall size is 60m * 60m.
There are quite a few machines in a single universe.
I managed to print the surface and texture of the ice rink,
to make the rotations of the architectural lights of the main track.
When I want to manage same rotate on lights of the small track they don't save.
Also when I install a color filter on a uv led panel (white to a purple) it does not save either.
Does anyone have solutions or is this part of the easyview2 bugs?
I'ld like to use 3D for working show off line to keep aéra maximum on production with minimum desagrements of light work
Thanks,
Ehouarn
https://www.leblizz.com/activites/
PS: config aéra
DVC4 511 addresses used 1universe
daslight 4 / easyview2 version 01/13/2020
60 gradators
8 zenith w600 wash panel 8circuits
4 ledstage rgb wash panel 6circuits
6 ledstage ls200z beam robo 20circuits
6 ledstage ls1240z wash robo 17circuits
10 patled 200 robo scan 7circuits some are coupled
3 coupled UV ledstage panel 2circuits
2 coupled smoke 1circuit
10 mac301 wash 16circuits some are coupled
easyview 3d Big aéra 60m*60m*8m
Re: easyview 3d Big aéra 60m*60m*8m
Hello,
It seems like this should be addressed to the support team over ticket, at this address :
https://store.daslight.com/en/support
Best regards,
It seems like this should be addressed to the support team over ticket, at this address :
https://store.daslight.com/en/support
Best regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500