Hi all,
I Have a DVC4 GZM that will be installed in "standalone mode" in a museum.
I have 3 scenes that must be activate by using the dry-contacts ports and after mapping the scenes to the ports I can see on the software that contact's waring light become green and the corresponding scene starts playing.
But when I disconect it from computer and run in stand alone mode, nothing happens... No scenes, no DMX signal... Even the -&+ pushbutton doesn't work in this mode.
Did I miss something? I Didn't find any help in manual.
I'm running on the last firmware avalaible.
Best regards
Best regards
Math
PB DVC4 GZM STANDALONE MODE WITH DRY CONTACTS TRIGGER
Re: PB DVC4 GZM STANDALONE MODE WITH DRY CONTACTS TRIGGER
Hello,
How did you write your scenes into the interface ?
Regards,
How did you write your scenes into the interface ?
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500