Sending Daslight 5 Show via ArtNet to another Software

[MikeMod]

Hey Folks,

I am curious about, to figure out, how I could send Daslight 5 Scenes (DMX Data) via ArtNet to another Software.

My hardware is a DVC Fun with a full license.
Some talked about a "ArtNet universe module" but where I can get this?
Do I really need this, for open a virtual device for sending DMX data from Daslight 5 to another software???

Other thing is, if I open QLC+ and open a local host ArtNet as Input, than open Daslight 5 I get a virtual device visible.

But it seems, that this do not work correctly.

The only thing is what I want, such most virtual DMX Controller can:

Sending DMX data from one software to another, for visualize for exampe in Unreal Engine (with a virtual ArtNet device)

If I use the same configuration in QLC+ I can send without issues to Unreal Engine.
But Daslight 5 has issues to send data out virtual to Unreal Engine.

Thank you in advance

[DJMan32]

so you have this set up properly, but you need a dvc device with proper license and an artnet channel bought before the software will allow you to output artnet

[MikeMod]

so you have this set up properly, but you need a dvc device with proper license and an artnet channel bought before the software will allow you to output artnet

Hi DjMan32,

thank you for the reply. Yes. I have a Daslight device but only the DVC Fun. In the webstore I cannot find any option, to buy an ArtNet module.
I would appreciate it a lot, if you could help me to get the ArtNet channel.
My license for the DVC Fun is a full license.

Is the update what I would need that one in the picture with the arrow and this works with the DVC Fun also?

[DJMan32]

yes, you need to purchase one of those

[DJMan32]

not actually another piece of hardware,

[MikeMod]

not actually another piece of hardware,

Great! Thank you for your kind help

I was not sure, if this is really for that ArtNet solution. Looking a bit confusing.