I have set up some scenes to trig from port and address. It doesn't respond to port commands. Everything else works as expected.
When I look in Tools/Test the Port state for port 3 and 4 is marked. I can see the closures works on the other ports.
Is it broken? It seems like port 3 and 4 are shorted, maybe a bad soldering. i don't want to resolder it since I maybe have to use the warranty.
I have updated the firmware (again) to 1.11
Any idea anyone?
Ports doesn't work *solved*
-
- Posts: 10
- Joined: Thu Feb 09, 2012 9:40 am
Ports doesn't work *solved*
Last edited by ljudkillen on Mon Apr 02, 2012 6:28 pm, edited 1 time in total.
-
- Posts: 10
- Joined: Thu Feb 09, 2012 9:40 am
This was a problem with a batch of interfaces. I guess you purchased 2 from the same batch. See here for more information:
http://www.nicolaudie.com/online_manual ... gY7Js2.htm
http://www.nicolaudie.com/online_manual ... gY7Js2.htm