Hi there,
i use an DVC 2 Interface SIUDI 8 C. Now i tried to test the new Virtual Controller Software. Within the update installation the Routine asked me to flash my dvc interface and i did it.
Now my controller does not work anymore. Neither with the old nor with the new software. It seems there is now outgoing dmx signal from the dvc interface to the devices.
What can i do now?
Helge
Interface does not Work after Firmware Update
Problem fixed
Hi there.
Met the team from daslight at the prolight & sound in frankfurt last saturday and they fixed my problem.
Big Thank You!
Helge
Met the team from daslight at the prolight & sound in frankfurt last saturday and they fixed my problem.
Big Thank You!
Helge
I think I answered your mail earlier today
Try to start the interface in bootloader mode with the tools app and write the firmware. To do this:
power off your interface
create a shortcut on p2-p3-p4-GND ports
power on your interface
start tools.exe
update the firmware
power off your interface
remove the shortcut
power on your interface
start tools.exe
update the firmware again
A ball of foil can be used as a quick way to connect the ports
Try to start the interface in bootloader mode with the tools app and write the firmware. To do this:
power off your interface
create a shortcut on p2-p3-p4-GND ports
power on your interface
start tools.exe
update the firmware
power off your interface
remove the shortcut
power on your interface
start tools.exe
update the firmware again
A ball of foil can be used as a quick way to connect the ports