Hi forum,
I'm trying to modulate a quite simple setting, but it causes more problems, than I thought it would.
Situation in real: Many traditional, non-LED PARs at stage. Most of them are equipped with a colour-filter-foil, so they are single colour.
What I like to do: Get them as single-channel PARs to DasLight4 with the square in the right colour and the right colour in the 3D-view.
I created a new ssl2-file, based on the generic PAR. I changed the Intensity-Preset to the colour red. (right-click, properties, specify a colour...). Sounds correct to me and should work. But if I save these setting and reload them, this setting is gone and set back to white.
Is this a bug? Or what did I do wrong? Do anybody know a good solution?
Colored Traditional PARs
-
- Posts: 3
- Joined: Sat Jul 30, 2016 1:22 pm
- Operating System: Windows
Re: Colored Traditional PARs
Hi Monster1965, can I check what version of Daslight / 3D viewer you are using? Please can you PM over your fixture profile so I can take a look here in the office? Cheers
Benno
--
Product Support
--
Product Support