Page 1 of 1
2 XLRS 3 PIN INTERFACE 1536 CH ??????
Posted: Wed Mar 23, 2011 5:37 pm
by stardustgr
http://www.nicolaudie.com/online_manual ... TE-gY7.htm THIS IS MY INTERFACE AS U CAN SEE IS 1536 CHAN WITH TWO 3 PIN XLR
AND NOT ONE XLR 3PIN AND ONE 5PIN FROM THE PROGRAM I CAN MAKE 3 LED RED TO LIGHT UP ONE FOR EACH UNIV
HOW CAN I TAKE 3X512 OUT WITH 2 XLR OUTPUTS ONLY?
TONY GREECE
Posted: Thu Mar 24, 2011 9:00 am
by simonB
If you have purchased the DVC2 GZM, it should come with 1x 3pin XLR and 1x 5pin XLR.
Please e-mail me your serial number.
Posted: Thu Mar 24, 2011 11:31 am
by stardustgr
no it has 2 xlr 3 pin
serial number is
Posted: Fri Mar 25, 2011 8:44 am
by simonB
Please e-mail me a photo of the front and rear of the interface. It sounds as though there has been a mistake. We will arrange an RMA over e-mail
Posted: Fri Mar 25, 2011 9:19 am
by stardustgr
sorry what is your mail?
photos
Posted: Fri Mar 25, 2011 9:44 am
by stardustgr
Posted: Sat Mar 26, 2011 9:29 am
by stardustgr
simon have u seen the photos ?????
Posted: Sun Mar 27, 2011 7:23 pm
by stardustgr
i am i going to get a reply from admin or not
Posted: Mon Mar 28, 2011 11:01 am
by simonB
Hi Tony
We don't work weekends. Please e-mail me your serial and I will set up an RMA. You can access my e-mail address by clicking the button which says "e-mail" underneath every post I make.
Posted: Mon Mar 28, 2011 12:00 pm
by stardustgr
hi simon i have send you the mail u want just reply and tell my if u get it
thx
tony greece