Daslight Forum

Hi!
In the DVC Gold datasheet (https://eu-litterature.n-g.co/Release/d ... eet_en.pdf) it says that
"The controller can be connected to an existing automation system using a local area network (LAN) and triggered via UDP packets on port 2430."

For more info about that it further says: "Refer to the remote protocol document for more information."

Where can I find this document? Please post a link here @simonB @TomHat. Thanks!

Best regards

Hello,

I need these information, too.

So please be so good and send the link

Thank you in advance.

Best regards.

Hello,

Sorry for the late reply.
Here is the document you need : https://eu-litterature.n-g.co/Release/s ... ontrol.pdf.

Hope this helps.

Best regards,

Hello TomHat,

thanks, helps a lot.

When the DVC Gold is in stand alone after power up, receive it the UDP commands sendet e.g. from a Streamdeck or receive DVC only in live mode UDP commands?

Thanks again.

Best regards.

Hello,

The UDP commands are only handled by the DVC Gold in Stand Alone mode.

Regards,

Thanks a lot for the document!